allconstructions.com [ Lithuania (LT), Latvia (LV, RU), Poland (PL), Germany (DE), Russia (RU) ] | anonsas.lt | leisureguide.info | autoreviu.lt | visasverslas.lt | viskas.lt | agrozinios.lt

Comments: 0   Views : 897

How To Install Carpet On Stairs
Print 2008-02-08 12:15  

Visitor rating 0.0 / Total 0.0
By: Jerry Holt
There are basically two methods of installing carpet on stairs. One is the waterfall method where one piece of carpet covers each riser and tread. The other is the cap and band installation. In this case the cap is a piece of carpet installed over the treads and the band is the piece that will cover the risers. In this article I will show you how to install carpet using the waterfall method. These instructions are for basic stairs and not for spiral stairs which would require additional procedures.

Tools Needed:

Tack strips
Staples or upholstery nails
Measuring Tape
Knee Pads
Knee kicker (check your rental store)
Stair Tool (check your rental store)
Utility knife
Hammer
Safety glasses

Obviously you'll need to remove all the old carpet. Get rid of the tack strips and don't try to use the old padding. Make sure any nails and staples are removed and sweep down the area to be carpeted.

Before you get started you're going to have to figure out how much carpet you'll need. To calculate the width simply measure across the tread. If your stairs are open on one or both ends make sure to measure under the nosing to where it meets the riser and add it to the total width. Figure the total length of your flight of stairs by measuring the tread and riser. Assuming your going to use carpet pad make sure to add at least 3 inches per stair. If your steps have nosing add one foot to the total flight measurement.

Okay, let's get started. Apply the tack strip to the stair crotch location. Next you'll need to tighten the carpet by tucking in the crotch. You can do this by using a knee kicker. It is a tool used to install carpet in small areas and stairs. It consists of a piece of metal tubing with a pin plate attached to it. On the other end it has a padded cushion where you can position your knee to apply pressure to the carpet. You should be able to find one at your local rental store. Simply place the padded end several inches above your knee and add pressure.

This is where you will use the knee kicker:

To attach to the tack strip you need to use the knee kicker to stretch the carpet straight from the center of the tread and hook it to the tack strip located at the crotch. Once the carpet has been hooked to the tack strip you need to firmly attach it by sliding your carpet tool back and forth to compress the pins. Using your utility knife or carpet knife trim as needed. A carpet knife is better as it has two sides and is sharper than a utility knife. Repeat this process on each side of the tread. Before going to the next tread make sure the carpet is smoothed out on the riser and then staple to the stair lip. I would recommend you staple about every 2 inches. Don't forget to also staple along the edge of the riser.

Make sure to step back and take a look at your work before going on to the next tread. Is the carpet smooth? Did you kick it in evenly? It is also a good time to give your knees and back a rest. If everything looks good the continue onto the next tread. If not you'll have to pull the carpet off and install it again. Repeat this process until you are finished.

Once finished stand back and admire your work and give yourself a pat on the back. You now have a beautiful looking staircase.
 
Jerry Holt is a writer for the website Do It Yourself Today. Please go to www.diytoday.net for do it yourself home improvement and decorating tips and advice.
 
Article Source: www.allgoodarticles.com

Categories: Carpet, Flooring, Stairs & Railing. Installation, Interior


 


Add your comment or vote!

Log in to leave a comment or vote or Sign up!



Menu:
 
 
 
Topic-related Companies

1 ... 398 399 400 401 402 403 404 405 406 ... 467

Straight Flooring

Hughli Cottage,Beaulieu Rd,Marchwood,Southampton, Hampshire
Phone: 023 8086 3509

Stratton Flooring Ltd

50,Bessemer Rd,Norwich, Norfolk
Phone: 01603 627106

Stripped Bare Flooring Services

43,Lodge Lane,Romford, Essex
Phone: 01708 765736

Strippo

77,Beech Lane,Macclesfield, Cheshire
Phone: 01625 869986

Stuarts Industrial Flooring Ltd

Stuart House,Dryden Vale,Bilston Glen,Loanhead, England
Phone: 0131 440 4000

Stuarts Industrial Flooring Ltd

Stuart House,Kingsbury Link,Trinity Rd,Piccadilly,Tamworth, Staffordshire
Phone: 01827 871140

Studio Tiling

191,Highters Heath Lane,Birmingham, West Midlands
Phone: 0121 436 5701

Suffolk Carpet Weavers

Unit 11a, Farthing Road, Ipswich, Suffolk
Phone: 01473 241999

Sullivan Flooring

4,Lion St,Hay On Wye,Hereford, Herefordshire
Phone: 01497 820077

Summit Contract Flooring

1a,Tamworth Rd,Lichfield, Staffordshire
Phone: 01543 256655

1 ... 398 399 400 401 402 403 404 405 406 ... 467